Yocto-I2C USB to I2C adapter
Yocto-I2C USB to I2C adapter was added to cart
The following products are required in order to use the Yocto-I2C USB to I2C adapter
USB to I2C adapter manufactured by Yoctopuce. It allows allow you to query circuits through an I2C bus. The Yocto-I2C powers external circuits with 1.8V, 3.3V or 5V DC. The I2C serial communication can be configured to operate at 1.8V or 3.3V. DC. The Yocto-I2C can act as an I2C master only.
The Yocto-I2C USB to I2C adapter can autonomously query and parse I2C data coming from any external I2C sensor. The measurements are exposed as a Yoctopuce sensor. The interface has all the inherent advantages: unique identifier, polling, callbacks, data logger. NOTE: this device does not work with applications designed to use a COM port: it is designed to be used with Yoctopuce API only.
This device can be connected directly to an Ethernet network using a YoctoHub-Ethernet. To a WiFi network using a YoctoHub-Wireless-n . To to a GSM network using a YoctoHub-GSM.
The Yocto-I2C is a 50x20mm module. It has an I2C port which can work at will with 3.3V or 1.8V. It also has an additional power supply which can provide 5V, 3.3V, or 1,8V. So you can, if necessary, power your device with a different voltage than that of the I2C bus, which is a rather common occurrence.
As for all Yoctopuce electrical digital interfaces, not only can you drive the Yocto-I2C directly from your program, but you can also use the embedded job system to present the results in the way of a Yoctopuce sensor, with all the advantages that go with it: callbacks, data logger, calibration.
The Yocto-I2C does not support a 5V I2C bus.
Note: the Yocto-I2C is designed to behave as an I2C master, you can’t use it to emulate an I2C slave.
This USB module can read up to five push buttons, potentiometers or resistive sensors (photodiodes, etc)
Ambient light sensor (luxmeter), for measuring light intensity from 0 to 100’000 lux, with built-in data logger.
USB interface driving an electromagnetic latching relay capable of switching directly mains powered appliances, up to 2000W.
Small device to measure the temperature with very high precision, using a PT100 temperature sensor (2, 3 or 4-wires supported). The device includes a built-in data logger to record measurements. The PT100 connection is electrically isolated from the USB bus.
USB device featuring a 3D accelerometer, a 3D gyroscope and a 3D magnetometer. This device can measure directly the 2D inclination, the magnetic orientation and provide a 3D orientation esimated based on inertial measurements.
USB interface allowing to connect up to 6 thermistors, PTC or NTC.
GNSS receiver (for GPS and GLONASS satellites) with integrated data logger
That device can generate two distinct PWM signals using a frequency between 1Hz and 1Mhz.
This device provides 8 digital I/O isolated from the USB bus.
Isolated USB motor controller (ESC) for brushed DC motors 3…18V / 20A, with integrated current, voltage and temperature probes.